Our eco-friendly hot water system could save you £300 a year on your fuel bills.
Low-voltage system
Attached directly to your tank and replaces the need for costly electric immersion heaters.
Ensures hot water
For a fraction of the price of a conventional electric powered immersion heater.
2 Hours to Install
The whole process takes as little as two hours and there’s virtually no mess at all.




Revolutionary Heating Sytem
The heat pads have a revolutionary, flexible heating element inside them. They are fixed horizontally to the tank in a ladder formation and once connected to a 24v transformer, they apply heat to the cylinder in horizontal bands, heating the hot water to 62°.
Each band is thermostatically controlled and, as the water in the tank heats up, the hot water rises to the top. Once the water has reached 62°, the heat pads turn off one by one and the water remains at a constant temperature until water is drawn off and cold water re-fills the bottom of the tank.

How are the Heat Pad Systems installed?
A section of the insulation material is removed from your tank.
Three heat pads are secured to the clean copper cylinder.
A control box is fitted close to the tank. This is the 'brain' of the system and powers the heat pads.
How do I know the Heat Pad Systems are safe?
The heat pad system will be installed by an NICEIC qualified electrician and will comply with BS7671.
The heat pad system has been tested to stringent European standards (certificate number C21/54803) and deemed to comply with: EN60335-2-21:2002 + A1:05 + A2:08 in conjunction with EN60335-1:2012 + A11:14 + A13:17 + A1:19 + A14:19 + A2:19.